Electrical power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Basic Description
This power unit is developed exclusively for that modest lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has become broadly employed from the business of logistic devices for instance minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is managed by the solenoid valve with all the speed controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is made exclusively to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve along with the velocity managed through the adjustable needle valve. When the lift rises to a large positoin, however the power supply is lower, the decreasing movement is controlled by the guide override perform.
Electrical power UNITS FOR LIFT TABLE three
Standard Description
This energy unit is made solely for the massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve along with the speed managed by a pressure compensated flow management valve.
Energy UNITS FOR LIFT TABLE four
Standard Description
This energy unit is built exclusively for that substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the velocity controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is lower, the reducing motion is managed from the manual override function.
Particular Notes
1. This energy unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned just before installation of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
4. Oil changing is required just after the initial a hundred operation hrs,afterwards the moment each 3000 hrs.
five. The electrical power unit shown is designed to be mounted vertically.