Material Handling Electrical power UNIT 1
General Description
This power unit is developed for your fork lift industry, consisting of highly productive gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down motion are controlled through the lever of the guide release valve, and that is equipped with an electric switch to activate the motor. The lowing speed is managed from the pressure compensated movement control valve.
Specific Notes
one. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic elements concerned ahead of set up of the power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which really should also be clean and free of impurities, N46 hydraulic oil is advisable .
four. Oil transforming is needed following the preliminary one hundred operation hours, afterwards when every 3000 hours.
5. The electrical power unit shown is built to be mounted horizontally.
Materials Managing Power UNIT 2
General Description
This electrical power unit capabilities electrical power up gravity down circuit. Activate the start out solenoid to start out the motor to lift the machine. The lowing motion is activated through the solenoid valve together with the lowering pace managed through the strain compensated movement handle valve. Products of this series is often widely used in the field of logistic units such as fork lift, mini lift table, and so forth.
Exclusive Notes
one. The duty of this power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean each of the hydraulic components concerned before mounting the power unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst,which must also be clean and free of impurities, N46 hydraulic oil is advised .
four. Oil changing is needed immediately after the first 100 operation hrs,afterwards as 
soon as every 3000 hours.
5. The power unit must be mounted horizontally.