Ways to connect O-ring Chains Remarks to connect standard O-ring Chains

1.A connecting hyperlink of an O-ring Chain for general application is pre-coated with grease in the pins. Ahead of connection, verify the grease about the surfaces of pins, and when the amount of grease is small, apply grease with bare hands. (If gloves are used, the grease will probably be absorbed through the gloves.)
Illustration: Once the connecting hyperlink (I) of an O-ring chain for standard application is
shipped, O-rings are fitted on the roots of the pins. If the O-rings come loose due to vibration all through transport, refit the O-rings in for the roots of the pins.
In this instance, make sure to return the grease collected at the roots of the pins towards the central surfaces from the pins, more at portion A than at portions B shown inside the above illustration. (Portions A is worn because of sliding together with the bushings.)
two.The chain may be most simply linked on the teeth of the sprocket. Engage the links at the two ends of your chain using the sprocket teeth and fit connecting pins. If the sprocket can be moved, the chain can also be connected to the loosened side.
3. Connecting process
one.Verify that O-rings are connected to your roots from the pins.
two.If your volume of grease applied over the connecting pins is modest, coat the pins with grease with the central portions.
3.Insert the connecting pins in to the bushings of your inner back links at each ends.
4.Confirm that the grease is applied for the entire face from the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins into the connecting plate and whilst pressing the connecting plate, install the spring clip. Confirm whether or not the head (the finish without a split) of your spring clip is turned while in the feeding path from the chain. (See the next illustration.)
6.Make sure you verify the spring clip is securely fitted within the clip grooves in the connecting pins.
This completes jointing from the connecting website link. Note that grease within the surfaces of connecting pins and O-rings is usually eliminated in the course of installation perform. In this case, re-grease utilizing the grease to the surface from the base chain or the grease within the polyethylene bag during which the connecting hyperlink was contained.