Transmission sprocket

Having been more than 20 years in the industry , we continue steadily to improve our items/quality and services as one of the market leaders today.
Why Ever-power?
Carburized Bushing
Carburizing process increases surface hardness and wear level of resistance, while the core remains difficult and ductile.
Shot Peening to All Components
All Omega’s conveyor chain components are very well shot peened, so that you can increase component life.
Ultimate Material Specification
New materials specification with better strength in chain breaking load, yet continues to be the most cost-effective choice.
Professional Technical and Item Support
Supported by experienced crew and established branches in strategic locations throughout China
Transmission Sprocket Installation
1. Install the tranny sprocket (with belt) on the primary drive equipment. 2. Install the sprocket nut. The next procedure is founded on whether a fresh or used nut is being installed. Note: The Tranny Sprocket nut has remaining handed threads. Turn the nut counterclockwise to set up on the key drive gear. Sprocket Nut: apply crimson thread lock to the threads of the sprocket nut. As well smear a small quantity of red thread lock or clean engine essential oil on the inside confront of the sprocket nut and the exterior face of the sprocket. Limit the application to where the surfaces of both parts contact each other. Install the sprocket nut until finger restricted. 3. Obtain Final Drive Sprocket Locking Software (BAKER P/N: Tool-C) to lock transmission sprocket. Proceed the following: A. Insert cope with of program below pivot shaft inboard of bottom frame tube and put on sprocket. B. Snug thumbscrew to lock location of tool on sprocket. 4. Obtain Mainshaft Locknut Wrench/Pilot (BAKER P/N: Tool-D). Proceed as follows: A. Install pilot on threaded end of mainshaft. B. Slide sleeve of locknut wrench over pilot and onto sprocket nut. C. Tighten sprocket nut to 60 ft-lbs. (81 Nm). As the nut is definitely tightened the manage of the sprocket locking application rises to get hold of the pivot shaft, thereby preventing sprocket/mainshaft rotation. 5. Scribe a straight collection on the tranny sprocket nut ongoing the brand over onto the tranny sprocket. Tighten the tranny sprocket nut an additional 35 to 40 degrees. 6. Install lockplate over nut so that the two diagonally opposing holes align with two tapped holes in sprocket. For the best match, lockplate can be rotated to a number of positions and can be located with either side facing sprocket. 7. If holes in lockplate usually do not align with those in sprocket, tighten sprocket nut as important (up to 45 degrees maximum) until sprocket and lockplate holes will be in alignment.

V-FACTOR
24 Tooth Sprocket Kit
Fits Big Twin 4 speed with rear disc

Tags:

Recent Posts

gearbox agricultural

As one of leading gearbox agricultural manufacturers, suppliers and exporters of mechanical products, We offer gearbox agricultural and many other products.

Please contact us for details.

Mail: sales@gearboxagricultural.xyz

Manufacturer supplier exporter of gearbox agricultural.